Technical Parameters - YATO YT-82806 Originalanleitung

SPECIFICATION OF THE PRODUCT
Cordless impact wrench is an ordinary powered power battery tool used for loosening and tightening nuts and bolts. Due to the
battery power the key can work without access to a continous power source. Correct, reliable, and safe operation of the electric
device is dependent on its proper use, therefore:
Prior to working with the device, you should read all the instruction and keep it around.
For any damage caused by failure to comply with safety regulations and instructions of this manual, the supplier is not respon-
sible.
EQUIPMENT
The product is supplied in a complete state and requires no assembly. Together with the product there are provided: the recharge-
able battery and charging station (charger).

TECHNICAL PARAMETERS

Parameter
Catalogue number
Operating voltage
Rotation (idle)
Impact frequency
Maximum torque
Noise level
- acoustic pressure
- LWA power
Protection grade
Insulation class
Level of vibration (drilling / screwdriveting)
Mass
Tool handle
Battery
Capacity of the battery
Charger
Input voltage
Mains frequency
Rated power
Output voltage
Input current
Time of charging**
** charging time applies only to the battery with a capacity listed in table
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
The plug of the electric cable must match the power socket. You must not modify the plug in any way. Do not use any
plug adapters with earthed power tools. An unmodifi ed plug that fi ts the outlet reduces the risk of electric shock.
O R I G I N A L
GB
Unit of measurement
[V]
[min -1 ]
[min ]
-1
[Nm]
[dB]
[dB]
[m/s 2 ]
[kg]
["/mm]
[Ah]
[V]
[Hz]
[W]
[V]
[A]
[h]
I N S T R U C T I O N S
Value
YT-82806
18 DC
0 - 2000 / 0 - 2600
0 - 5000
350 / 700
86,0 ± 3,0
97,0 ± 3,0
IPX0
III
7,58 ± 1,5
1,8
1/2 / 12,5
Li-Ion
3
220 - 240
50 / 60
50
21,4 DC
2
1,5
11