Lightmaxx LS-4000 PRO WIND-UP STAND Bedienungsanleitung Seite 14

ENGLISH
Commissioning:
Be sure to check the unit for damage before use. Use the original packaging or suitable transport
or storage packaging to protect the product from dust, moisture, etc. when not in use.
Assembly of the stand:
To adjust the stand width, first loosen the locking screw (1) and
pull out the fixing bolts (2).
Insert the fixing bolts at the desired height into the hole of the
stand rod and tighten the fixing screw again.
Before using the stand, ensure that all locking screws and fixing
bolts are secured.
If the stand is to be set up on a staircase or other uneven
surface, first loosen the locking knob (3) and pull out the fixing
bolt (4).
Pull out the tripod leg until the desired position is reached. Now
reinsert the fixing bolt into the hole in the tripod leg and tighten
the locking screw again.