Whirlpool ADN 231 Betriebsanleitung Seite 5

When positioning the appliance, be careful that the electrical cord isn't
–
squeezed in order to avoid its damage. Do not store heavy objects such as
cooling devices, furniture or other devices next the appliance in such a way that
they could squeeze and damage the electrical cord. This can cause a short
circuit and a fire.
Make sure that the plug of the electrical cord is not squeezed by the back wall
–
of the appliance or otherwise damaged. A damaged plug can be the cause of a
fire!
CAUTION! If the installed interior lighting diode (LED) lamp for the cooling
–
device is not functioning, contact the maintenance and repair representative for
replacements. LAMPS CAN BE REPLACED ONLY BY THE MAINTENANCE
AND REPAIR REPRESENTATIVE.
Requirements for safe use:
Once the appliance is unpacked, make sure that it is complete, that the body
–
and the electrical cord aren't damaged. It is forbidden to use a technically
damaged appliance.
If the appliance is unplugged (for cleaning, moving to another place, etc.), IT
–
MAY BE REPEATEDLY SWITCHED ON AFTER 15 MIN.
When performing activities, such as cleaning, maintenance or moving, the
–
appliance must be completely disconnected from power supply (by pulling the
plug out from the socket). Do not pull on the cord, but hold the body of the plug
instead.
Do not place any switched on electrical devices on top of the appliance because
–
this may cause ignition of plastic parts.
Do not place any dishes with liquids on top of the appliance and do not keep
–
flowers in vases or other liquid-filled vessels on the appliance.
Do not climb on or sit on the appliance, do not lean on or hang on the appliance
–
doors and do not allow children to do this.
Do not use water spray and steam to clean the appliance.
–
Do not try repair the appliance on your own. If the appliance is out of order
and it is not possible to repair it by means of given recommendations, unplug
it, open the doors and call the service expert. Only a service representative
can remedy all technical or construction faults.
The appliance should be transported only in the vertical position.
The manufacturer will not be responsible for any damage of the appliance
that results from non-compliance with the instructions for transportation.
4