Installation - Neptun Massagestation Montage- Und Betriebsanleitung

installation

Delivery contents in accordance with fig. 1 except gate valve, block- off set and all pipings.
The installation can take place according to the customers` request (the position of the mas-
sage nozzles). The mounting parts for the massage nozzles can be installed as required.
The given dimensions are only suggestions. For longer lines, the pipes should be enlarged
by one dimension.
The installation kit for the massage station must be covered with the enclosed building pro-
tection so that all threads are protected. Please mind the installation arrangement.
mounting of the flat gasket to the built-in pot
DThe site of the pump must be chosen as close as possible to the installation kit. In addition,
make sure that the pump is mounted voltage- and vibrationfree on solid base or a suitable
panel. Furthermore, you have to provide an outflow possibility as well as an adequate ven-
tilation to prevent a flooding of the site. That`s the only way how a trouble-free operation
can be guaranteed.
The air valve must be mounted vertically upwards and above the water surface. ll the pipe
fittings, required for a scheduled piping, are included. Should, however, extensions may
be necessary, keep the pneumatic hose as short as possible (max. 4 m), and don`t crincle or
clamp it in any way. In addition, make sure that in case of modified piping, only bends and
45° T-pieces but never angles must be used. Similarly, a piping of the next larger nominal
size should be worth to compensate possible pipeline resistors.
The pneumatic hose must be placed and fixed on the control box (fig. 1) If possible install
the PN-hose above the water level.
The Pneumatic hose must be placed on the control box (fig. 1) .
It has to be installed above the water level.
15