Troubleshooting - GE AG16AB2TAA Installations- Und Benutzerhandbuch

TROUBLESHOOTING

First try the solutions suggested here to possibly avoid the cost of a service call.
Problem Probable cause
The unit does not The unit is not connected to the mains.
work.
The wall outlet is not working properly.
The water container is full.
The device does
The water container has not been replaced
not dehumidify.
correctly.
The air filters are clogged.
The air inlet or outlet are covered.
The temperature or relative humidity in the
room where the device is operating, are too
low.
The room is too large.
The dehumidifier
works, but reduces
There are too many sources of humidity.
the relative humidity
insufficiently.
There is too much ventilation.
The unit is not placed on a flat surface.
The unit is too noisy
The unit is not placed in its upright position.
The filters are blocked and need cleaning.
Possible solution
Insert the plug into the wall outlet
Check to make sure that your wall outlet
works properly.
Remove the water from the container.
Place the water container in the correct position.
Clean the air filters.
Remove any obstruction from the unit's inlet
or outlet.
It is normal that the device does not dehumidify
in these conditions.
We recommend using a dehumidifier with a
greater capacity.
We recommend using a dehumidifier with a
greater capacity.
Reduce ventilation (e.g. close windows and
shut doors).
Place the unit on a flat and stable surface.
Place the unit in its upright position.
Remove and clean the filters of the device.
9