Intended Use - Deuba monzana 102660 Bedienungsanleitung

INSTRUCTIONS
4
ATTENTION! Read the safety and assembly instructions carefully, in order to avoid
the risk of injury or damaging the product.
Important: Read these instructions carefully and thoroughly. Keep these instructions
to read through at a later date. If you give the product to anyone else at some point
in the future, please ensure you also pass on this manual
Only for domestic use and not for
commercial use! .
Keep small parts, plastic bags and other packaging out of the reach of children.
Pay attention especially when unpacking your item. Danger of suffocation!
Check the delivery for completeness. Later complaints cannot be accepted.
Check all elements and parts for damages. Despite careful control, products may be
damaged in transit. In this case, do not assemble your product. Defective parts can en-
danger your health.
Never modify the product! Changes will void the warranty and the product may
be unsafe or even dangerous.
Unpack all the parts and elements of the set and place the components on the top of
the carton or other clean surface. This protects your new product.
Please also pay attention not to scratch the floor while working with tools.
Make sure that this product is fully assembled before use, as shown in the illustration
For cleaning use a sponge and warm soapy water.
Do not use solvent based-cleaners or detergents - for example bleach. Those can dam-
age the product.
Use the product only for its designed purpose of use. Manufacturer will not assume
any responsibility in case of damages cause of an unappropriated use. Any modification
applied by customer on the original product will have a negative impact on its safety,
cause danger and warranty will be canceled.
Disposal:
Once item end-of-life, please dispose valuable raw materials for a proper recycling. If
you are not sure how to handle it in a correct way please contact your local disposal or
recycling centers for advice.
www.DeubaXXL.de

Intended Use

Open the quick-locks and pull out the tripod up to the desired length. Close the quick-
locks again. (No. 102660)
Connect the water hose with the quick coupling.
Make sure to tighten all connections in order to avoid dripping.
For circle watering of 360° lift up the spring (2). For sectional watering turn the collars (3)
in the desired position. The radius of the section can be determined by positioning the
spring between both collars. Use the ray-sturgeon stud (1) to adjust the throw width
and drop size.
1
3
Adjusting mode
A) Adjusting the range of throw
B) Adjusting the water diffusion
C) Adjusting the circle watering
Use
2
www.DeubaXXL.de
5