RADICAL R-C10VW1 Montageanleitung Seite 12

6. Connect one of the main connection
cables (No. 11) of the Radical device
(No. 1) to the Plug connector of the
car and close its locking mechanism.
Following this, connect the CAN bus
interface (No. 12) to the main
connection cable. Connect all the
cables to the Radical device (No. 1)
those previously run in the radio bay
and the original antenna cables.
7. Neatly arrange the wires to the side,
making room for the ZENEC system.
Carefully slide it into the radio slot
and fix it in place, using the four
original Torx screws.
8. Mount the trim frame back on to
make the installation complete.
The installation of your R-C10VW1 is
now complete.