Canton DM 90.2 Bedienungsanleitung Seite 45

DM System – Functions
No inputs except "radio" can be selected
DM System does not recognise Dolby Digital or DTS data stream
No signal from Zone2 / Line - Output
RC only displays "surround" instead of "surround 1" and
"surround 2"
Distorted radio reception
A set radio station is no longer available once the system has
been switched off and on again (display back on 87.50)
Sound and image are not (lip)synched
1. No inputs have been registered in the "input config" menu
(e.g. initial installation was terminated with "exit")
2. During the configuration process the "up" or "down" arrow
keys and / or the "exit" key were used
1. The source is only connected to the analog port (Line 1 or 2)
2. The wrong settings have been selected on the source device
1. There should be a multi-channel signal from Zone2 / Line
2. The volume for Zone2 is set too low
1. The DM System has been set to 4.1 or 5.1 mode
1. Poor aerial position
2. Poor geographical location
3. The station has not been properly set
1. The station was not allocated a programme slot
1. Long processing times in the TV delay the image
45
1. Register the relevant inputs in the "input config" menu
(m => System Setup => input config). Follow the exact
instructions on page 36!
2. Register the relevant inputs in the "Eingangskonfig" menu
(m => System Menu => Eingangskonfig) and only use the
correct keys (see page 36)
1. Connect a digital output from the source device to Opt 1 / 2
or Coax 1 /2
2. Select "Bitstream" or "Raw" as the data format on the
source device (referring to the instructions given for the
source device)
1. Set "dynamic" (m => System Setup => Dynamic) to „comp",
under "Output Config" (m => System Setup => Output
Config => Input) select "zone 1" as the input and on the
main screen select the desired source as input
2. Increase the volume for Zone2 – output under "Volume"
(m => System Setup => Output Config => Volume)
1. Set the system to 2.1 mode under "system preset" (m =>
System Setup => factory setup => System Preset)
1. Arrange the extended (!) aerial as openly as possibly, well
away from metal surfaces
2. Use a roof-mounted aerial or a broadband cable connection
3. Tune the station manually, following the instructions on
page 39
1. Simply press the "OK" key to save a station in Programme
Slot 1
1. Delay the sound in "lip sync" (m => System Menu => lip
sync) so that the image and sound are synchronised (simulta
neous)