Installation - Zelmer ZTW1500 Benutzerhandbuch

EN
Do not touch the appliance with wet hands or feet.
Do not drag the appliance by the cable to move it.
Do not pull the cable or the appliance itself to remove the plug from the mains socket.
To clean the appliance, follow the instructions in the manual in the section dedicated to cleaning and
maintenance.
EUROGAMA will not be held liable for any harm or damage which may occur to people, animals or
objects as a result of failure to observe the aforementioned warnings.

INSTALLATION

After removing the packing, check the condition of the appliance; if in doubt, do not use it and consult
professional qualified technician. The packaging (plastic bags, polystyrene, fixtures, etc.) should be kept
out of the reach of children, since they are a potential source of danger, and they should be disposed of
in the appropriate specific containers for selective waste collection.
Before connecting the appliance, check that the voltage values indicated on the characteristics plate
correspond to those of the electric mains supply. In the event that the socket and the appliance plug
are incompatible, have the plug changed to one that is suitable by a professional, qualified technician,
who will check that the cable part of the plug is adapted to the power used by the appliance. In general,
the use of adapters or extension leads is not advised; if this were to be necessary, they must be in
accordance with the safety regulations and their amperage capacity must not be less than the maximum
for the appliance
Before each usage, check that the appliance is in good condition and that the power cord is not
damaged: if in doubt, check with professional qualified technician.
The socket must be easily accessible in order to be able to disconnect the appliance with ease in case of
emergency.
Do not place the unit on top of a shelf and/or near a wash basin or any container with of liquid (leave a
distance of at least 2 metres) to prevent the risk of it falling into the liquid.
Place the fan away from fabrics (curtains, etc.) or volatile materials that may obstruct the ventilation
grille; also check that the front of the fan is free of volatile materials (dust, etc.).
Place the appliance away from all heat sources (e.g. naked flames, gas stoves, etc.).
The supporting surface must be stable and flat and even (so that the appliance does not tip over).
ASSEMBLY
CAUTION: Ensure the product is fully assembled before plugging it into an electrical outlet.
1. Insert the power cord into its slot between the two base halves.
2. Connect both base halves together by aligning their pegs/peg holes.
3. Attach the motor housing to the assembled base by inserting and securely tightening the three screws
into the screw holes (at the bottom of the base).
4. Position the power cord into its routing slot at the rim center of the base (rear).
a. Remove the three screws form the brace; then remove the brace.
b. Position the power cord into its slot.
c. Reposition the brace and securely reinsert the 4 screws.
USE
CAUTION: Press only one of the speed control push buttons at a time. Permanent damage to the switch
housing may result if two or more of the buttons are pressed simultaneously.
1. Always operate the product on a flat, level, steady, and stable surface to avoid it overturning.
2. Plug the product into a standard electrical outlet.
3. To turn the fan on, rotate the
push button (0-OFF, 1-LOW, 2-MEDIUM, 3-HIGH), as desired.
8
/ / TIMER switch to the position and push the speed control