Manual Operating Mode; Assembling Fixed Setpoint Controller Sm Wr Fr On Mixing Valves On Different Mixing Makes; Installation Of The Fixed Value Controller Sm Wr Fr With Kit 100 (Delivery) - WITA SM WR FR Installationshandbuch

Operating instrutions
5.7

Manual operating mode

In the event of a fault, the fixed setpoint controller can be switched from automatic
to manual operation, thereby enabling emergency operation..
6 Assembly of fixed setpoint controller SM WR FR
The fixed setpoint controller SM WR FR may only be fixed to different mixer
makes using the attachment kit for the respective manufacturer.
Please observe the data sheet of the mixer to be installed (torque) when selecting
the drive! The attached assembly instructions are to be observed during assembly using
the attachment kits for specific manufacturers! The fixed setpoint controller is equipped with a
special mounting flange. Simple assembly of the fixed setpoint controller on the mixer or valve
or disassembly without tool assistance is possible by activating the assembly/disassembly but-
ton.
6.1 Installation with kit 100 (scope of delivery) on heating mixer of the series
WITA H6 ,WITA H10
WITA Minimix
WITA Maximix
Meibes alt
32
WITA Fixed setpoint controller SM WR FR
Button knob (4) for manual operation
Button (3) for manual operation
• press - manual operation
• press - again for automatic operation.
The graphic display indicates it the
button is pressed for during manual
operation!
Delivery scope
Note
Basic display
Note