SC iStick Power Bedienungsanleitung Seite 43

41
SC iStick Power – Operating and changing the vaping mode
Explanation of the TC-Ni, TC-Ti, TC-SS and TCR (M1, M2, M3) modes
When set in TC-Ni/TC-Ti/TC-SS mode, the device can separately support Nickel 200, Titanium and 316 Stainless
Steel coils� In TCR (Temperature Coefficient of Resistance) mode, the device can support different temperature
control coils within different TCR value ranges� You can set the TCR at different values within proper range� When
set in one of these modes, the device supports a coil resistance within the range of 0�05 ohm to 3�5 ohm�
Adjusting the TCR mode
While the iStick Power is turned off, press and hold the fire button and „up" button at the same time for about
5 seconds to enter in the TCR-menu:
1� Press "up" or "down" buttons to switch between TCR M1, M2 and M3�
2� Confirm the desired mode by pressing the fire button�
3� Press the "up" or "down" button to increase or decrease the TCR value according to the material of the used coil�
Downloaded from www.Manualslib.com manuals search engine