Maintenance/Repair; Recycling - i.safe MOBILE IS-RSM1.1 Kurzanleitung

is prohibited . This device may affect proper work of medical equipment, such
as pacemakers, so always keep a distance of at least 15 cm between the device and
these devices .
Observe all corresponding laws that are in force in the respective countries regarding
the use of devices while operating a vehicle .
Please power off the device and disconnect the charging cable before cleaning
the device .
Do not use any chemical cleaning agents to clean the device or the charger .
Use a damp and anti-static soft cloth for cleaning .
Do not discard old and abandoned lithium batteries into the trash, send them
to designated waste disposal locations or return them to i.safe MOBILE GmbH .
WARNING
i.safe MOBILE GmbH will not assume any liability for damages caused by disregarding
any of these advices or by any inappropriate use of the device .
I.SAFE PROTECTOR
The IS-RSM1.1 contain specially designed safety circuits . Connecting the charger
to non-ex-approved equipment like a computer can endanger the safety of the
device, as faults in the non-approved equipment could lead to a power surge into
the device large enough to destroy the safety circuits .
The i.safe PROTECTOR is a USB cable for connecting the device with non-ex-
approved equipment . It contains additional safety circuits to protect the device
from possible faults in the non-ex-approved equipment .
For this reason, charging and data connection is only allowed using the i.safe
PROTECTOR .

MAINTENANCE/REPAIR

Please note any legal requirements for periodic inspection .
The device itself has no user-serviceable parts . It is recommended to perform
inspections according to the safety regulations and advises .
If there is a problem with the device, please contact your vendor or consult the service
center . If your device is in need of repair, you can either contact the service center or
your vendor .
BATTERY
The battery in this device is not removable by the user . The battery is not fully charged
when the device is purchased, but it contains enough energy to power on the device .
To obtain best battery performance and battery life, let the battery discharge comple-
tely before charging it completely for the first three charging cycles .
CHARGING THE BATTERY
Connect the i.safe PROTECTOR USB cable to the USB connector at the bottom of
the device . Connect the other side of the i.safe PROTECTOR USB cable with the so-
6
Downloaded from www.Manualslib.com manuals search engine
cket of the power adapter . After charging, please disconnect the i.safe PROTECTOR
USB cable from the power adapter .
BATTERY USE
In actual use the run time of the device varies with the network status, working envi-
ronment and usage . If you do not charge for a long time, the device will be powered
off automatically .
WARNING
The device may only be charged at ambient temperatures in a range from 5°C ... 35°C .
Please do not use charging equipment if the temperature exceeds this range .
POWERING ON/OFF THE IS-RSM1.1
[Power key]
Press the until the blue LED lights up . A tone will confirm the readiness .
Press the [Power key] again and a tone will confirm the powering off .
PAIRING IS-RSM1.1 WITH YOUR DEVICE
In the powering OFF mode, press and hold the
When the IS-RSM1.1 has entered the pairing mode, the indicator light flashes red
and blue alternately .
Turn ON the Bluetooth on your mobile device and search for the IS-RSM1.1 . Select
and match . When LED indicators turn to blue, the pairing succeeds .
KEYS AND SPECIAL FEATURES
(see illustration on page 2)
1
POWER KEY: Power ON/OFF the IS-RSM1.1
2
EARPHONE JACK: The built-in speaker will be shut down automatically when
the earphone is plugged in . Do not open the earphone ack in hazardous areas .
3
RESET KEY: Press to restart the IS-RSM1.1
4
VOLUME UP KEY: To control the volume up .
5
VOLUME DOWN KEY: To control the volume down .
6
USB-PORT: To connect the delivered USB cable for charging .
7
CHARGING CONTACTS: For charging with the optional desktop charger .
8
PTT KEY: Long press for speaking and use PTT (for example BPER) .
9
SOS KEY: To trigger the One-Button-Alarm on Mandown-Detection-APP
(supported phone models and application provided!) .

RECYCLING

The crossed-out wheeled-bin symbol on your product, battery, literature, or packaging
reminds you that all electrical and electronic products, batteries, and accumulators
must be taken to separate collection at the end of their working life . This requirement
applies in the European Union . Do not dispose of these products as unsorted municipal
[Power key] for about 8 seconds .
EN 7