MA lighting MA VPU light Kurzanleitung Seite 29

Switching the apparatus On/Off
Caution: Do not power down during booting. Such a switch-off may lead to corruption of the solid state disk files.
Power switch
Position I = ON
In the I position, the instrument is in standby mode or in
operation, depending on the position of the
ON/STANDBY key at the front panel.
Note:
The AC power switch may remain ON continuously.
Switching to OFF is only required when the instrument
must be completely removed from the AC power source.
Position O = OFF
The 0 position implies an all-pole disconnection of the instrument from the AC power source.
Standby switch
The ON/STANDBY switch activates two different operating Modes:
Operation ON
STANDBY
Switching On the Instrument
In order to switch on the apparatus, set the power switch on the rear panel to position I.
Set the apparatus to operating mode by pressing the ON/STANDBY button on the front panel.
Switching Off the Instrument
In order to switch off the apparatus, push the ON / STANDBY button on the front panel and confirm with the softbutton "YES". In this
standby mode, the AC power voltage is present within the instrument. For longer non use switch the power switch to "0".
Downloaded from www.Manualslib.com
AC power switch on the rear panel
ON/STANDBY button on the front panel
First push on ON/STANDBY - button
The apparatus starts booting.
Second push on ON/STANDBY – button
The apparatus switch to standby - mode
Caution: In standby mode, the AC power voltage is present within the apparatus
manuals search engine
VPU light
Data
Transport
Important
Safety
Instructions
Safety and
Environment
Quickstart
Connect
Quickstart
ON / OFF
Maintenance
Conformity
28