Can Ead; Sleep Mode; Programming Mode; Otating The - PSC SP*ACE Benutzerhandbuch

S M
LEEP ODE
Sleep Mode is the term used to describe the scanner's condition after
the motor and/or laser have automatically switched off due to a
prolonged period of inactivity.
P
ROGRAMMING
Programing Mode is a special condition used to change scanner
features such as the user interface, scanner to host interface param-
eters, or laser and motor time-outs. Programming Mode also
disallows scanning of normal barcodes or sending data to the host.
A set of special programming barcodes are contained in the Pro-
gramming Kit (R44-1140) that is available from PSC or your dealer or
distributor.
R

OTATING THE

The SP* ACE scanner's head can be
rotated 270° degrees (180° for-
ward and 90 ° backward) to
accommodate many scanner
mounting options. Follow the
instructions below to rotate the
scan head.
Grasp the scanner as shown.
GAP
Rotate the scanner head to the
desired position and release the
head. If the gap doesn't close, rotate
the head slightly until the gap
closes.
4
M
ODE
S H
CAN EAD
SCANNER
BODY
Pull the scan head to the right
and the gap between the two
halves will open. This releases the
locking mechanism.
SP*ACE User's Guide
SCANNER
HEAD