ASROCK Fatal1ty E3V5 Performance Gaming/OC Serie Schnellinstallationsanleitung Seite 25

Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 22)
Chassis Fan Connectors
(4-pin CHA_FAN1)
(see p.1, No. 13)
(4-pin CHA_FAN2)
(see p.1, No. 12)
(4-pin CHA_FAN3)
(see p.1, No. 19)
(4-pin CHA_FAN4)
(see p.1, No. 6)
Downloaded from www.Manualslib.com
1
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must sup-
port HDA to function correctly. Please follow the instructions in our manual and chassis
manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by the
steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to connect
them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel and
adjust "Recording Volume".
4
FAN_SPEED_CONTROL
FAN_SPEED_CONTROL
FAN_SPEED
FAN_VOLTAGE
manuals search engine
Fatal1ty E3V5 Performance Gaming/OC Series
This header is for
GND
PRESENCE#
connecting audio devices
MIC_RET
OUT_RET
to the front audio panel.
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
Please connect fan cables
3 2 1
to the fan connectors and
match the black wire to
GND
FAN_VOLTAGE
FAN_SPEED
the ground pin.
4
3
2
GND 1
21