Hama Trexis Bedienungsanleitung Seite 6

Making a call
• Dial the number directly on your terminal device
to make a call.
Voice-activated dialing
• Please check if your mobile phone supports voice
dialing function.
• Press the multi-function key (3)
can hear a short beep.
• Say the name of person you wish to call.
• If the voice tags are paired to the related phone
number stored in your mobile phone, the number
will be dialed.
6.4 Accepting calls
• Press the multifunction button (3) once to
answer an incoming call.
Rejecting an incoming call
• Press and hold the multifunction button (3) for
approx. 2-3 seconds to reject an incoming call.
Ending a call
• During a call, press the multifunction button (3)
once to end the call.
Redial
• Briefly press the multifunction button (3) twice
to call the last number.
• You will hear a short beep.
Forwarding a call
• During the call, press and hold the multifunction
button (3) for approx. 3 seconds to forward the
call from the headset to the terminal device or
from the terminal device to the headset.
5.4. Volume control and mute function
• Press the volume control (-) (2) to reduce the
volume.
Downloaded from www.Manualslib.com
briefly, then you
manuals search engine
• Press the volume control (+) (4) to increase
the volume.
• A short acoustic signal sounds twice when the
maximum volume is reached.
• Press and hold the volume control (+) (4) for
approx. 3 seconds. You will hear short beeps of
increasing pitch. The headset's microphone (7)
is muted; the device beeps in short intervals to
remind you of this fact.
• Press and hold the volume control (+) (4) for
approx. 3 seconds to deactivate the mute function.
You will hear short beeps of increasing pitch and
then decreasing pitch.
5.5. Disconnecting the headset
• Switch the headset off.
• Disconnect the headset via the Bluetooth
on your terminal device.
5.6. Battery level
• To save energy, the headset automatically switches
off if it is not connected to a device for longer
than 10 minutes.
• If the battery level is low, the headset beeps
every 20 seconds, and the status LED (6) starts
flashing red.
• Charge the headset as described in 4. Getting
Started.
Note
However, the talk and standby times may vary
when used with different mobile phones or other
compatible Bluetooth
devices, usage settings,
®
usage styles and environments.
settings
®
5