Set The Alarm Timer; Protect The Disc - Kruger&Matz KM1598 Bedienungsanleitung

SET THE ALARM TIMER

This unit can be used as an alarm clock. You can select DISC, USB or TUNER
as alarm source.
Note: Ensure that you have set the clock correctly.
1. In standby mode, press and hold the TIMER/SLEEP button until [TIMER
SET] (set timer) scrolls on the display.
2. Press VOLUME UP/DOWN
3. Press TIMER/SLEEP button, the hour indicator will blink.
4. Set the hour with the VOLUME UP/DOWN
5. Press TIMER/SLEEP button, the minute indicator will blink.
6. Repeat above steps 4-5 to set the minute.
7. Repeat above steps 4-5 to set the alarm volume.
Activate / deactivate alarm timer
In the standby mode, press TIMER/SLEEP button repeatedly.
• If timer is activated, the
• If timer is deactivated, the
Note:
• To exit timer setting mode without storing, press the STOP
• If no button is pressed in 90 seconds, the unit exits clock setting mode automatically.
• If DISC/USB source is selected and the audio cannot be played, TUNER is
activated automatically.

PROTECT THE DISC

• To keep the disc clean, please don't touch the disc's surface when you are
holding it. You should hold the edge.
• If the disc is dirty, it will affect the sound quality. Please use the clean and soft
cloth to wipe the disc from inside to outside. Don't wipe the disc in circular motion.
• Don't stick paper on the disc.
• After you have finished with the disc, please place it back in its original case.
To avoid warping or damage, do not stack discs.
• Don't play the disc which has flaw or deformation, in case of damaging this player.
• Clean your discs using only a soft dry cloth. Do not use any chemicals such as
benzine, thinner, antistatic or record sprays as these can damage the disc surface.
38
/ button on the remote control to select source.
/
icon is displayed.
icon disappears.
Owner's manual
buttons on the remote control.
button.