Eco-Power/Standby Features - Kruger&Matz KM1598 Bedienungsanleitung

Owner's manual

ECO-POWER/STANDBY FEATURES

Powering ON/OFF
When you insert the AC power cable into a wall outlet, the unit will be in standby mode.
• Press the STANDBY button to switch the unit on. The word "HELLO" will
show in the display.
A countdown of 10 seconds starts for preheating of the system. Then, the
system will switch to the last selected source.
• Press the STANDBY button to switch the unit back to standby mode. The
words "BYE BYE" will scroll across the display.
Switching the system to ECO Power/Standby mode
Press and hold the
Power Standby or normal standby.
• ECO Power standby mode
The clock will not be displayed. Press the CLOCK button to display the clock
on the LCD (if set).
• Normal standby mode
The clock (if set) display on the LCD.
SETTING THE CLOCK
Setting the Clock Manually
1. Set the unit in standby mode.
2. Press and hold the CLOCK button to activate the clock setting mode, [24]
begins to blink on the LCD.
3. Set the 12/24 hour format with the
4. Press the CLOCK button, hour indicator will blink.
5. Set the hour with the
6. Press the CLOCK button, minute indicator will blink.
7. Set the minute with the
8. Press the CLOCK button, the built-in clock starts operating.
Note:
• To exit clock setting mode without storing, press the STOP
• The clock must be set in standby mode and if the set-up time for each step
is longer than 90 seconds, set-up will be cancelled.
• If a power failure occurs or the unit is disconnected from the mains, the clock
setting will be lost.
Setting the Clock Automatically
When the RDS station display the time, press and hold the DISPLAY button on
the remote control, the clock will automatically sync time of RDS.
standby button for 2 seconds or more to switch to ECO
/ (VOLUME UP/DOWN) buttons.
/ (VOLUME UP/DOWN) buttons.
/ (VOLUME UP/DOWN) buttons.
button.
31