Setting Instruction; Unit Setting; Backlight Setting - Kerbl 29923 Bedienungsanleitung

6.0 SETTING INSTRUCTION

Hold [TARE] and turn on the scale to enter the setting mode. It will show the selection of parameter.
Press [Mode] to go to the selection.

6.1 Unit setting

This function is for the setting of unit mode. The unit can't be shown on the scale if it is turned off by this
setting in weighing mode. Press to select the units, press to turn on or off the units.
The details are follow:

6.2 Backlight setting

The function is for the setting of backlight. When the display shows bl 2, press [ZERO] to select the back-
light mode.
6.3 Communication interface setting
Communication interface setting includes sending mode, address and BPS selection. Please refer to 7.1
communication protocols in addenda to see the details of protocols.
Communication mode
This function is for selecting communication mode. There are four modes selectable: continuous transfer
mode, response transfer mode; stable transfer mode and printing mode.
23