Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Instructions; Proper Use - Heitronic 500032 Installations- Und Bedienungsanweisung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

GB Installation and Operating Instructions
IF-Motion sensor with E27-socket
Art. No. 500032
These operating instructions solely relate to the above product.
They contain important information for the start-up and handling of the Motion sensor.
Therefore pay attention to these operating instructions, even if you pass this product on to third
parties.
It is important, therefore, that these instructions are archived carefully for referring to information at a
later stage.
1. Introduction
Dear customer, thank you for deciding to purchase our product.
You have acquired a product from Vollmer, which has been built according to the current state of technology.
The Motion sensor fulfils the requirements of effective European and national guidelines.
To maintain the condition of the product and to ensure safe operation, you - as the user - must observe the
instructions of this operation manual!

2. Safety Instructions

In the event of damage which is caused by not following these operating instructions,
the warranty is rendered void.
We do not accept liability for any consequential damage!
Commissioning is strictly prohibited if there are any damages to the Motion sensor.
Do not allow the Motion sensor to come into contact with extreme heat or naked flames.
The product in its entirety must not be altered or modified. Alterations to the light invalidate the
guarantee.
The type plate must not be removed.

3. Proper Use

The Motion sensor is designed for use in indoor areas.
This product is only intended for lighting purposes and may:
only be operated with a voltage of 230 V ~50 Hz
only be operated on normal or non-flammable surfaces
not be subjected to strong mechanical loads or heavy soiling.
4. Before Installation/Commissioning
The Motion sensor may only be operated once removed from the packaging.
Remove the Motion sensor from the packaging carefully.
Make sure that the Motion sensor has not been damaged during transport before taking it into operation.
The Motion sensor may not be operated if there are any damages to electrical parts. Repairs may only be
carried out by a qualified electrician.
Keep packaging materials away from children and pets. Asphyxiation hazard!
1 of 2 | Dated 28.09.2018

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis