Herunterladen Inhalt Inhalt Diese Seite drucken

Funktionsweise; Principle Of Operation; Test Button - Eaton CEAG 3-PM Montage- Und Betriebsanleitung

Inhaltsverzeichnis

Werbung

6 Funktionsweise

Das CEAG 3-PM-Modul hat zwei getrenn-
te Relaiskontakte, welche bei einen Ausfall
einer Phase schalten und somit eine 24 V
Schleife zum Zentralbatteriesystem öffnen
können . Vorzugsweise werden die Kontakte
S/S hierzu verwendet . Und die Kontakte 123
als Meldeeinrichtung für eine übergreifende
Störmeldeeinrichtung .
Die grüne LED in der Frontplatte signalisiert
störungsfreien Betrieb der angschlossenen drei
Phasen .
Am Ende der 24V Stromschleife ist ein
Abschlusswiederstand (1000 Ω) zu installieren .
Test Taster
Der Test Taster löst nach Betätigen eine Netz/
Notlichtstörung an dem jeweiligen ZB-S,
AT-S+ oder LP-STAR Gerät aus und die ange-
schlossene Sicherheitsbeleuchtung schaltet in
Dauerlicht .
Gleichzeitig geht die grüne LED L1 aus .
Manual CEAG 3-PM Module 40071860336 July 2018 www.ceag.de

6 Principle of operation

The CEAG 3-PM module has two separate relay
contacts, which can switch in case of a phase
failure and thus open a 24 V loop to the central
battery system . Preferably, the S/S contacts
are used for this purpose . And contacts 123 as
a signalling device for a comprehensive fault
signalling device .
The green LED in the front panel signals inter-
ference-free operation of the connected three
phases .
A terminating resistor (1000 Ω) must be fitted at
the end of the 24V current loop .

Test button

The test button triggers a mains/emergency
light fault on the respective ZB-S, AT-S+ or
LP-STAR system after actuation and the con-
nected emergency lighting switches to perma-
nent light .
At the same time, the green LED L1 goes out .
5

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis