Product Disposal - Zelmer ZCL6040 Benutzerhandbuch

EN
Dry the appliance carefully and check that all the electrical parts are not wet: if in doubt, contact a
qualified technician.
In order to avoid the creation of odors and ensure the unit works properly, it must be cleaned internally
once every two weeks.
Remove the back panel, by loosening the two attachment pins and lifting the panel upwards, off the 2
upper attachment points. Remove the filter and the honeycomb filter from the unit.
Wash the filter in warm water with a mild, soapy solution; use a soft brush if necessary. Rinse with clean
water and leave to dry.
Wash the honeycomb filter with clean water and a soft brush if necessary. Leave to dry.
Empty the water tank and clean with water, a mild soapy solution and a soft brush if necessary. Rinse
with clean water and leave to dry.
In case of long periods of non-use store the appliance, protecting it from dust and moisture; we
recommend using the original packaging.
If you decide to stop using the appliance, it is advisable to render it in operational by cutting the power
cable (first ensuring that the plug has been disconnected from the mains socket) and making sure that
parts which could be dangerous to children (e.g. the blade) may cause no harm.

PRODUCT DISPOSAL

This product complies with European Directive 2012/19/EU regarding electrical and electronic
devices, known as WEEE (Waste electrical and electronic equipment), which establishes the
applicable legal framework in the European Union regarding the elimination and recycling
of electrical and electronic devices. Do not put this product in the bin. Take it to your closest
electrical and electronic waste treatment centre.
The product may use batteries. Remove them before disposing of the product and deposit
them in the special containers approved for this purpose.
We hope you are satisfied with this product.
Description
Maximum fan flow rate
Fan power input
Service value
Standby power consumption
Fan sound power level
Maximum air velocity
Measurement standard for service value
12
Symbol Value
F 400
65,0
P
SV 6,15
P 0,128
SB
L 55
WA
C 7,5
IEC60879:1986(CORR.1992)
Unit
m³/min
W
(m³/min) / W
W
dB(A)
m/sec