Troubleshooting; Technical Specifications - Finether C19B Bedienungsanleitung

V. Maintain the filter
1. Press the battery locker to disconnect
the Battery from the bin
3. Take out the filter case , then take out
the filter
5. Dry the HEPA filter and filter case
completely before placing them back
7. Put the filter case back to the bin
8
2. Open the bin (shown as below)
4. Wash the filter case and HEPA filter
6. After drying , assemble the filter to
the case
8. Assemble the dust cover into the dust
cup (Shown as below)

Troubleshooting

PROBLEM LIGHT POSSIBLE CAUSE
1.The adapter is not inserted into
the wall socket properly.
No light 2.Battery part does not connect
with the bin part
3.The charger is damaged
The appliance is
not charging
After a long time
of charging, the
red light keeps There should be some problem
flashing for 10 with its internal PCB board
seconds and then
turns off
The main Red light flashes
1.Low battery
unit does after you press the
2.The roller brush is blocked by hair
not function power on button
or something else
properly
The main unit
works normally Green light lights 1.The rubber belt of the brush bar
but the brush up as normal may be loose
bar won't spin
The appliance
has a lower Green light lights 1.The bin is full
suction power up as normal 2. Brush's axis is twined by hair
than usual

TECHNICAL SPECIFICATIONS

Battery voltage 22.2V
Charging time 4 hours
Net Weight 2.3kg
Run time 40min (low speed), 25min (high speed)
Power 120W
Vacuum Suction 7kPa
20m 3 /s
Airflow（max）
Battery volume 2200mA
Bin volume 500ml
SOLUTION
1.Make sure that the adapter is inserted
into the wall socket properly.
2.Make sure the battery part slides into
the bin part with a clear "click" sound
3.Change for a new manufacturer
recommended charger
Please contact us for help or take it
repaired by a professional.
1.Fully charge the appliance
2.Remove obstacles from the roller
brush
3.Please contact us for help or take it
repaired by a professional.
Please contact us for help or take it
repaired by a professional.
1. Clean the bin
2. Clean the filter according to
instructions
3. Clean the hair
9