Getting Started - Cybres Mu3 Kurzanleitung

1. Install the redistributable package for visual C++ 2012 (32/64 bit versions are in
the directory 'drivers').
2. After connecting the device first time to PC, Windows will detect the MU EIS
device as unrecognized 'USBUART' device. In the Device Manager with the right
button click open the device settings and in manual mode show the pass to the
'USBUART_cdc.inf' file (file is included in the directory 'drivers'). After completing
that the MU EIS device should appear as 'USB Serial Device (COM X)'.
3. The client program does not require installation. All the necessary files are
contained in MU-EIS-Client directory.
4. Plotting is carried out by any program that can read numerical data from files (e.g.
Microsoft Excel). The developers propose to use the free program gnuplot, however
the decision to use this software lies entirely on users. To install the gnuplot program,
run the installation file 'gp503-win64-mingw.exe' and install the program in the
default directory. During the installation make sure that PATH environmental
variable is set. If the gnuplot was installed into another directory, or the correct
installation failed, you need to set the correct path and also in the PATH command.
These steps need to perform only once when software is first time installed into your
PC. Updates of the client program are performed only by replacing the program
folder.
1. Connect the USB cable to the device and select the COM port.
2. Configure the application (EIS, biosensor, phytosensor) and connect the
selected electrodes.
For real-time plot, check the checkbox "online plot enable".
3.
Press the button "Measurement Start".
4.
Software installation (Windows 7, 8, 10)

Getting started