Maintenance - NRD Neutralizer AC 6500 Bedienungsanleitung

Maintenance

The Neutralizer
signed to be durable, dependable, and trouble
free. It requires a minimal amount of mainte-
nance. Each application and environment in
which static control is required is different, mak-
ing it difficult to state accurately how often
cleaning or maintenance is needed.
After a period of use, a small sphere of dust will
accumulate on the emitter pin. Do not allow this
accumulation to continue indefinitely. Although
an ionizer may continue to perform satisfactorily
when it is dirty, gross contamination will de-
grade its efficiency.
The Neutralizer
signed with a replaceable emitter pin, and comes
with one (1) replacement pin. NRD recommends
that the emitter pin be replaced every three months.
Emitter pins may need to be replaced more often
depending on the amount of use. Additional re-
placement emitter pins are available by contacting
NRD.
This ionizer is categorized as "non-shockless".
This means there is a High Voltage Shock Haz-
ard. Insert the safety key into the battery jack
and attach the trigger lockout clip behind the
trigger while maintenance is performed. Also,
use caution whenever handling ionizers since the
emitter pin is sharp and can cause punctures or
scratches if mishandled.
Safety
key
Original Instructions
Downloaded from www.Manualslib.com

AC Ionizing Blow Gun is de-

AC Ionizing Blow Gun is de-
Trigger
lockout clip
2937 Alt Boulevard / PO Box 310 / Grand Island, NY 14072-0310
716 773 7634 /
PHONE
manuals search engine
Replace the emitter pin as follows:
1. Turn off the compressed air.
2. CAUTION: To avoid shock hazard insert
the safety key into the battery jack and attach
the trigger lockout clip behind the trigger.
3. Carefully squeeze tabs together and slide
the air nozzle off of the Neutralizer
Ionizing Blow Gun.
Pull pin
down
4. Using a pair of tweezers or pliers remove
emitter pin from the pin holder, then
through the outlet hole of the ionizer. Dis-
pose of the emitter pin.
CAUTION: do not bend the pin holder.
5. Insert the new emitter pin using the twee-
zers or pliers. Be sure to push the emitter
pin in as far as it will go.
Tab
CAUTION: do not bend the pin holder.
6. Carefully slide the air nozzle back over the
tabs and snap it into place.
7. Remove the safety key and the trigger lock-
out clip. (Do not discard, save to use later)
8. Turn on the compressed air.
Tab
716 773 7744 / sales@nrdinc.com /
FAX EMAIL

AC
Pin
holder
Emitter
pin
www.nrdinc.com
WEB
INSTNeutralizerAC – 11/10