Herunterladen Inhalt Inhalt Diese Seite drucken

NRD Neutralizer AC 6500 Bedienungsanleitung Seite 3

Ionisierende blaspistole
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

The battery should be charged completely prior
to first use or if the green LED does not light
when the trigger is depressed.
Charge the battery as follows:
Safety key
When LED indicator is Green the battery charger
will not over charge the battery.
Installation and Operation
Warranty Note: Failure to use clean, dry, filtered,
compressed air will VOID warranty.
Air filters remove oil, water, and other debris
from compressed air that could impede perfor-
mance of the Ionizing Blow Gun.
Original Instructions
Downloaded from
www.Manualslib.com
Remove the safety key. (Do not discard,
save to use later)
Battery jack
Connect the DC battery plug to the Neutral-
izer
AC battery jack.
LED Indicator
AC Plug
Connect charger to AC power source.
LED indicator is Red when charging and
Green when charge is complete.
When charging is complete, disconnect
charger from AC power source and then
the Neutralizer
AC.
2937 Alt Boulevard / PO Box 310 / Grand Island, NY 14072-0310
716 773 7634 /
PHONE
manuals search engine
Attach the Ionizing Blow Gun to a 1/4"
1.
NPT hose fitting. Screw the fitting secure-
ly into the base of the handle. Use thread
sealant as needed.
2.
Connect and turn on compressed air to
Ionizing Blow Gun.
3.
Regulate the air pressure to desired level.
Do not exceed an inlet pressure of 50 psig.
4.
Remove the safety key. (Do not discard,
save to use later)
5.
Squeeze trigger to begin air flow and acti-
vate the Neutralizer
Gun. Green LED on top of Ionizing Blow
Gun will be lit to verify the air ionizer cir-
cuitry is activated.
6.
Move the Ionizing Blow Gun in a slow
sweeping path, at a distance of 12", cover-
ing the entire part. A powerful stream of
ionized air will flow over objects and
quickly neutralize electrostatic charges,
remove dust and other foreign particulate
clinging due to static attraction.
Note: Any contact, such as additional tacking,
after the surface has been cleaned and ionized
may result in re-charging the surface with static.
We recommend that you repeat the cleaning of
the part with the Ionizing Blow Gun. This en-
sures the static charges have been removed.
DC Plug
Tab
Tab
Air nozzle
Trigger
7.
When the Neutralizer
Gun is not in use, use the ring to hang it
from a hook.
716 773 7744 /
FAX
EMAIL
AC Ionizing Blow
Green LED
Ring
1/4" NPT
AC Ionizing Blow
sales@nrdinc.com /
www.nrdinc.com
WEB
INSTNeutralizerAC – 11/10

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis