AirPatrol SmartHeat RoomUnit Bedienungsanleitung Seite 9

4. Select which actuators to control with RoomUnit by pressing UP / DOWN
buttons on ControlUnit. Yellow blinking LED shows selected actuator. To select
the actuator press SELECT button. Green blinking LED shows that the actuator
is paired to the RoomUnit. Red LED means that the actuator is already in use by
another RoomUnit.
5. Press PAIR button on ControlUnit when actuators for RoomUnit have been
selected. Pairing LED will turn green. To pair another RoomUnit to actuators
repeat steps 3-5. To exit pairing mode press PAIR button on ControlUnit, pairing
LED will turn off.
6. Pairing ends automatically on
RoomUnit when connection is
established. In order to see ZONE
number press RoomUnit UP botton for
5 seconds.
Downloaded from www.Manualslib.com manuals search engine
9