Batter Y Notes - Mocreo HitX Bedienungsanleitung

If there is no connected device before, the indicator then will flash in blue and red as
the headphone searches for a new Bluetooth-enabled device.
You must release power button after the three quick flashes. If you keep pressing
and holding power button for another 3 seconds, the headphone will get into
PAIRING mode directly.
To turn the HitX off
Press and hold the power button for 5 seconds, the red LED on the headphone will
quickly flash for three times, release the power button, the headphone is now turned off.
Note:
The headphone will be turned off automatically if no device connected within 30
minutes. If you want to use the headphone, please kindly restart it.
Pair Your Device Manually by Bluetooth
1. Press the Power button for 5 seconds. Wait for the indicator flashes in blue and red
as the headphone searches for a Bluetooth-enabled device.
2. Turn on your device's Bluetooth (refer to your device' s user ' s guide).
3. When MOCREO HitX appears in the Bluetooth devices list, pair it with your device.
4. You can control the music play through your device or with the headphone's
buttons.
Pair Easily by NFC
If your Bluetooth device supports NFC (Near Field Communication), you can pair the
headphone easily.
1. Press the Power button for 5 seconds. Wait for the indicator flashes in blue and red
as the headphone searches for a Bluetooth-enabled device.
2. Turn on your device's Bluetooth and NFC (refer to your device's user 's guide).
3. Touch the NFC area of your device against the NFC logo on the headphone. Follow
the pairing instructions that appear on your device. The headphone and your device
will pair automatically.
4. You can control the music play through your device or with the headphone's
buttons.
Note:
If a smartphone is connected and you receive a call, answer the call by pressing
If your device uses Bluetooth 2.0 and below, enter the password 0000 for Bluetooth
connection.
Downloaded from www.Manualslib.com
-3-
manuals search engine
If the connected device moves too far away from the headphone, the headphone
disconnects from the device but resumes connection once the device is close.
If you want to connect with a new Bluetooth device, please unpair the previous ones
due to the storage memor y function.
Use AUX IN
For audio devices without Bluetooth function, use a 3.5mm audio cable (included) to
connect it to your headphone's AUX IN jack .
Note:
Bluetooth is automatically deactivated when AUX IN is connected.
The headphone controls are irresponsive for AUX IN connections. Use the controls
on your device to control music play
Warnings
Do not operate the headphone if it has been damaged in any way.
Do not place heavy objects on top of the headphone.
To avoid electromagnetic interference, do not place the headphone on top of a TV
or other electrical appliance.

Batter y Notes

Recycle batteries. Do not dispose of in the trash. Do not burn or bur y batteries. Do
not puncture or crush. Do not disassemble.
Charge batteries on a fireproof surface away from flammable items or liquids.
Do not charge inside an automobile, especially while driving.
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and
water. If in the eyes, rinse thoroughly with cool water. Immediately seek medical
attention.
Specifications
Driver Diameter
.
Impedance
Frequency Response
40 mm
32 ohm
20Hz-20kHz
-4-