Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Protection system
This unit has 10 different protection modes. When the induction cooker shows a malfunction, it will stop
working and an alarm will sound. The digital display shows the fault code. Pressing the ON/OFF button
will clear the display and will turn off the cooker. Wait for 1 minute and turn the cooker on again. If the
display shows an error again, there is something wrong with the cooker. The error details are listed
below.
Showing
Cause and handle method
EO
The circuit has a malfunction. The cooker shows "EO" and automatically stops working.
Check and replace the motherboard.
E1
The pan is not suitable or there is not a pan on the plate. The cooker shows "E1" and
automatically stops working. Replace with a suitable pan in the centre of the plate.
E2
IGBT (Insulated Gate Bipolar Transistor) overheats. The cooker will stop heating after the
buzzer has "beeped" 5 times. Wait for the IGBT to cool before using.
E3
Voltage surge protection. When the input voltage is over 275 V, the cooker will stop
working and show "E3". It will work again when the voltage returns to the 145-275 V
range.
E4
Low voltage protection. When the input voltage has already dropped below 145 V, the unit
will stop working and show "E4".
It will work again when the voltage returns to the 145V-275V range.
E5
The sensor of the top plate was open or has short circuited.
The unit will stop working and show "E5". Check all inner parts and replace if necessary.
E6
The sensor of the IGBT was open or has short circuited. The cooker will stop working and
show "E6". Check all inner parts and replace if necessary.
E7
The top plate has overheated and the cooker has stopped working. Allow to cool.
Specifications:
HA-INDUC11:
1).
Power rate: 2000 W
2).
Voltage: 230 V AC ~50 Hz
HA-INDUC12:
1).
Power rate: 2000 W
2).
Voltage: 230 V AC ~50 Hz
HA-INDUC21:
1).
Power rate: 2x1700 W
2).
Voltage: 230 V AC ~50 Hz
4
Werbung
Inhaltsverzeichnis
