Safety Precautions; English - Comet SC 140 Betriebs- Und Wartungsanleitung

S P
AFeTy recAuTIONS
_fi«
ATTENTION
• Follow the safety instructions and the type of use described in the high pressure cleaner
instruction manual.
• T he floor/wall cleaner attachment must only be used with the following models of high
pressure cleaner: KL, Xstar, KSM, KS. Using it with other models may be dangerous.
• The floor/wall cleaner must not be used by children or by untrained personnel.
• During operation make sure that there are no people or animals in the vicinity of the floor/wall
cleaner.
• For cleaning, servicing, and storage, always carry out the stopping operations described in the
high pressure cleaner manual. Always remember to disconnect the electric power supply.
• Activate the high pressure water jet only when the floor/wall cleaner is in contact with the surface
to be cleaned. During use, never place your hands or feet under the floor/wall cleaner.
• Use the floor/wall cleaner only for level surfaces: do not use it on kerbs, steps, or in any case
where there are protruding elements.
• The packing materials must be kept out of the reach of children, as they are a potential source
of danger. Dispose of all packing materials according to the current regulations.
O
PerATION
CAUTION
•_ Use the attachment only for cleaning floors or walls made of wood, concrete, tile, or natural
stone, taking care that the surface to be cleaned cannot be damaged by the high power jet (for
example: painted or wallpapered walls).
Adjust the cleaning force of the floor/wall cleaner according to the surface to be cleaned.
Release_the_shaft_
6
towards the _"Soft" position (for more delicate surfaces) or the
S
surfaces). Lock the shaft by moving the selector, without forcing it, to the
Using on floors
Engage the bayonet coupling of the floor/wall cleaner
the locking nut . Operation
3
Switch off the high pressure cleaner by moving the master switch to the "0" position and connect
the floor/wall cleaner lance
Restart the high pressure cleaner by moving the master switch to the "1" position and press the
lever of the spray gun to activate the floor/wall cleaner.
To operate press the hand grips of the spray gun and the lance.
Using on walls
Engage the bayonet coupling of the floor/wall cleaner
the locking nut . Operation
3
Switch off the high pressure cleaner by moving the master switch to the "0" position and connect
the_adapter_ to the spray gun, tightening completely. Operation
4
Restart the high pressure cleaner by moving the master switch to the "1" position and press the

eNgLISH

by moving selector
_of_
A
Fig. 1
to the spray gun, tightening completely. Operation
2
_of_
C
Fig. 1
_to_the_ _"Unlock"_position;_then_move_the_shaft_
U
7
H
on the lance
1
.
_on_the_adapter_
1
.
_"Hard" position (for less delicate
_"Lock" position.
L
and completely tighten
2
B
and completely tighten
4
_of_ .
C
Fig. 1
_of_ .
Fig. 1