Display Change - Kettler toys NEVADA 2 Montageanleitung

Functions
Change from animation to tachometer operation
Press the SET button longer. The segments represent a tachometer.

Display change

The automatic display change is stopped by means of short pressure on the SET but-
ton. The current display is maintained. The symbol is blanked. It can be reactivated by
repeated short pressing of the SET button, until the symbol appears again.
Switching off the display
The display will be switched off after 1 minute without pulses from the sender or if no but-
ton is pressed to spare the battery.
Switching on the display
The display will be activated by pressing the SET button. All segments are shown briefly.
Afterwards, the total kilometres are displayed.
Display of total kilometres (odometer)
The total kilometres are shown briefly with odo in line 1 and the value in line 2.
Input of the wheel diameter
The wheel diameter is preset at 320 mm (for Nevada II). It can only be changed after
having inserted the battery. In line 1 SEt appears and in line 2 the wheel diameter is flas-
hing briefly. By pressing the SET button, you can increase this value. By pressing it for a
longer period of time, you can change the adjustment speed. Complete the input at the
desired value. When changing to the odometer display, this value will be accepted.
Kilometres or miles setting
The electronics is preset to kilometres. This means that all values are shown in kilometres.
The divided circle represents the current setting.You can only change it to miles
after having inserted the batteries. Press the SET button, when all segments are displayed.
Press the SET button again, while km is flashing. The symbol m is displayed for miles set-
ting. Line 1 shows SEt and in line 2 the wheel diameter is flashing briefly, now set in Inch.
By pressing the SET button, you can increase the value. By pressing it for a longer period
of time, you can change the adjustment speed. Complete the input at the desired value.
When changing to the odometer display, this value will be accepted. The divided circle
represents .
Deleting the display
By pressing the display for a longer period of time, the display is restarted.
Battery voltage
The electronics recognises low battery voltage and displays it by means of LOBatt. You
should change the batteries not later than at this moment. Low battery voltage in the sender
is not recognised. If pulses are not transmitted anymore during driving, check the battery of
the sender.
Malfunctions
Take the batteries out in case of strange action of the training computer, check the battery vol-
tage and put the batteries in again.
12