Getting Started - STRIPMEISTER E250 Bedienungsanleitung

Getting Started

1. Secure the STRIPMEISTER™ machine to a ridged work bench.
- Mounting holes provided.
2. Ensure speed control is set to 0 and the machine is off.
3. Plug the STRIPMEISTER™ machine into a 120-240VAC outlet.
4. Loosen the Wire Guide(s) and raise the Cutting Knife enough to fit the
uncut wire.
5. Insert wire into smallest possible Lower Wire Guide opening
- For E1000 and up, if the wire is too large for the drilled holes, secure the
Lower Wire Guide at its lowest position.
6. Bring down the Cutting Knife until it touches the top of the wire.
7. Lower the Wire Guide to achieve a wire angle of 10-20° and tighten.
- For E1000 and up, rest the Upper Wire Guide on top of the wire and
tighten.
8. Remove the wire.
9. Use the Knife Height Adjustment Wheel to lower the Cutting Knife by
roughly the insulation thickness. Fine tune adjustment will happen in step
11.
10. Turn the machine on a low speed (Only increase speed after set up is
complete).
11. Insert a short length of wire and adjust the Cutting Knife height if
necessary.
- Ideally, only cut the insulation and not the copper.
- When cutting ROMEX, ensure the outer casing AND one insulated inner
lead is cut in a single pass. This will save time.
12. Remove the insulation.
- When stripping large wire, run cable twice (180° apart). This makes
removing thick, stubborn insulation easier.
13. Happy Stripping!
© 2016-2020 Wire Strip Meister Inc
Revision 4.0
Page 5 of 8