Safety Instructions; Proper Use - Heitronic 29700 Installations- Und Bedienungsanweisung

GB Installation and Operating Instructions
Conductor rail system
Art. No. 29700-29703
These operating instructions refer exclusively to these products.
They contain important information for the start-up and handling of the product.
Therefore pay attention to these operating instructions, even if you pass this product on to third
parties.
It is important, therefore, that these instructions are archived carefully for referring to information at a
later stage.
1. Introduction
Dear customer, thank you for deciding to purchase our product.
You have acquired a product from Vollmer, which has been built according to the current state of technology.
The conductor rail system fulfils the requirements of effective European and national guidelines.
To maintain the condition of the product and to ensure safe operation, you - as the user - must observe the
instructions of this operation manual!

2. Safety Instructions


The guarantee becomes invalid if damage occurs due to the failure of following these operating
instructions!

We do not accept liability for any consequential damage!

Commissioning is strictly prohibited if there are any damages to the product.

Do not allow children to play unsupervised in the vicinity of the product or other electrical appliances.

Do not touch the light with your bare hands during operation.

Do not allow the light to come into contact with extreme heat or naked flames.

The product in its entirety must not be altered or modified. Alterations to the product invalidate the
guarantee.

The type plate must not be removed.

3. Proper Use

The product is designed for use in dry and protected indoor areas.
This product is only intended for lighting purposes and may:

only be operated with a voltage of 230V ~50Hz

only be connected according to protection class I (one)

only be operated when mounted to a sturdy, level and non-tilting surface

only be operated on normal or non-flammable surfaces

not be subjected to strong mechanical loads or heavy soiling.
1 of 3 | Dated 26.01.2016