nedis BTTC200BK Kurzanleitung Seite 9

Transmitter mode (image D)
Option 1:
1. Set the AUX / SPDIF switch A
7
2. Set A
to TX.
r
3. Plug B into A
4. Plug the other end of B
4
You can also connect an audio device with the stereo audio cable 2x RCA
male to 3.5 mm female B
Option 2:
1. Set the AUX / SPDIF switch A
7
2. Set A
to TX.
y
3. Plug B into SPDIF input (Tx) A
4. Plug the other end of B
5. Switch on the product.
6
A
Blinks green.
6. Keep your Bluetooth audio device within range and switched on.
4
Pairing time will vary depending on the device used.
6
4
A
Burns to indicate pairing is successful.
Connect a second device
• After successfully connecting the first device, press A
second device.
4
The devices must be one meter apart from each other.
4
The two devices are connected simultaneously.
4
If the pairing does not work, switch the product off and on.
Disconnect paired devices
• Press and hold A
4
To disconnect a single device, switch off the Bluetooth of that device.
1
8
.
r
into your audio source.
e
.
1
y
into your audio source.
5
for 3 seconds.
to AUX.
to SPDIF.
9
.
9
5
again to pair to a