Mounting Instructions - HQ Power VDPLDJBAR6 Bedienungsanleitung

• All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to
the device is not covered by the warranty.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
lamp explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the
device against damage by leaving it switched off until it has reached room temperature.
• This device is designed for professional use on stage, in discos, theatres, etc. The VDPLDJBAR6 should
only be used indoors with an alternating current of 230 VAC/50 Hz.
• Lighting effects are not designed for permanent operation: regular operation breaks will prolong their lives.
• Keep this manual for future reference.
4. Features
• ultra-light weight: special for DJ and mobile use
• movable spots, per spot there are 4 tri-colour LEDs for a smooth colour mixing
• preprogrammed modes, with presets for colours and RGB programs
• auto mode speed adjustable, and built-in microphone for sound activation
• easy control via included foot pedal, with black-out function.
5. Overview
Refer to the illustrations on pages 2 and 3 of this manual.
A connector for LED spot (4x)
B earth terminal
C power socket + fuse
D tripod securing knob
E DMX input
F DMX output
G microphone
H microphone sensitivity control knob
I connector for footswitch
6.

Mounting instructions

6.1 Choosing a Mounting Location
The VDPLDJBAR6 batten has been designed for indoor environments at temperatures up to 40°C. For
proper operation, the unit must be operated with an unobstructed air convection to its metal housing.
Do not:
• Operate the batten in environments with an ambient temperature higher than 40°C and a relative humidity
higher than 75%.
• Operate the batten in a closed environment smaller than 10 m³ unless forced air convection is provided.
6.2 Secure Mounting
Risk of injury. Overhead mounting requires extensive experience: calculating workload limits,
determining the installation material to be used... Have the material and the device itself checked
regularly. Do not attempt to install the device yourself if you lack these qualifications as improper
installation may result in injuries.
The VDPLDJBAR6 batten is designed to be mounted either on a tripod (not incl.) or on a truss (not incl.) using
2 truss clamps (not incl.).
Tripod:
• Carefully follow the instructions that came with your tripod.
• Make sure that the diameter of the inserted tripod tube is not less than 25 mm as otherwise secure
mounting cannot be guaranteed.
V. 02 – 01/06/2012
Downloaded from www.Manualslib.com manuals search engine
VDPLDJBAR6
J DIP switch
K mounting points
L horizontal fixing knob
M vertical fixing knob (2 per spot)
N LEDs (4 per spot)
O program selection pedal
P sound control pedal
Q freeze pedal
R blackout pedal
5 ©Velleman nv