Status SP300 Originalanweisungen Seite 6

3. FUNCTIONAL DESCRIPTION
4. PREPARE TO USE
FUNCTIONAL DESCRIPTION
See Fig. A
1 . Nut
2. Air cap
3. Nozzle
4. Seal
5. Knob
6. Filter housing
7. Air compressor assembly
8. Trigger
9. Material adjustment knob
10. Container
11. Handle
12. Viscosity cap
PREPARE TO USE
WARNING: Always unplug the tool before assembly and
adjustment
Assembly (See Fig. B)
1. Turn both knobs on both sides of the Air Compressor Assembly to the "Unlock"
position, and Insert the spray gun into the Air Compressor Assembly into place,
2. Turn both knobs on both sides of the Air Compressor Assembly to the "Lock"
position to lock the two pieces into place.
Aligning the suction tube (See Fig.C)
1. If you are going to be spraying in a downward direction, the angled end of
the suction tube should be pointing toward the front of the gun.
2. If you are going to be spraying in an upward direction, the angled end of the
suction tube should be pointing toward the rear of the gun.
3. By pointing the suction tube in the proper direction, you will not have to refill
the container as often.
Material preparation
Before spraying, the material being used may need to be
thinned with the proper solvent as specified by the material
manufacturer. Never exceed the thinning advice given by
the coating manufacturer.
Do not use materials with a flashpoint below 70°F (21°C).
Follow the instructions below.
EN
10
5. SPRAYING
1. Stir the spraying material thoroughly before measuring viscosity.
2. Dip the viscosity test cup completely into the spraying material.
3.Hold the test cup up and measure the time in seconds until the liquid empties out.
This time is referred to below as Runout Time.
THINNING CHART
Material
1) Oil enamel
2) Oil based primer
3) Oil stain
4) Clear sealer
5) Polyurethane
6) Varnish
Material to be sprayed should always be strained to remove
any impurities in the paint which may enter and clog
the system. Impurities in the paint will give poor performance
and a poor finish.
MATERIAL FLASH POINT MUST BE 70°F (21°C) OR HIGHER.
Fill Container
1. Unscrew the cup from the spray gun.
2. After the material has been properly thinned and strained, fill the container
to the top of the neck.
3. Carefully screw the cup back onto the spray gun.
SPRAYING
The spray pattern adjusting (See FigD).
The spray pattern shape is adjusted by turning the ears of the air cap (1) to either
the vertical, horizontal, or diagonal positions. The positions of the air cap (1) and
the corresponding spray pattern shapes are illustrated.
Test each pattern and use whichever pattern is suitable for your application.
NEVER trigger the gun while adjusting the ears on the air cap.
NEVER point the spray gun at any part of the body.
Material flow adjustment (See Fig.E)
Set the material volume by turning the regulator (1) behind the trigger of the spray
gun.
Runout Time
25-40
30-45
No thinning required
No thinning required
No thinning required
20-50
11
EN