Cleaning And Maintenance - Salora FT-410 Benutzerhandbuch

• Raise all locking clips of the front fan guard (Fig.3)
• Now place the front fan guard in place against the outer ring and
put all the clips downwards again. Now fix the two fan guards
together using the bolt and nut (Fig.4).
OPERATION OF THE DESK FAN
ATTENTION:
• Choose a suitable location for the fan. Always choose a location that
meets the safety requirements stated in this manual.
• When placing the fan on a table or board, always check that the cord
cannot be pulled accidentally or that the appliance can fall over.
Never hang the fan on a wall or ceiling.
•
• Remove the cable tie and unwind the cable completely before using
the fan.
• Loosen the neck screw to set the desired wind direction angle by
pushing the motor and fan blade up or down to the desired position
(Fig. 5). Then tighten the screw.
To disable the oscillation function, which causes the fan to only blow in
•
one direction, pull the oscillating knob upwards. To re-activate this
function, push the oscillating knob downwards again (Fig.5).
1. Switch on / off and control speed
The device can be switched on and off and the speed can be controlled
by means of the speed switch. You can choose from the following
modes:
0 The fan is off
1 The fan is at the lowest setting
2 The fan is at the middle setting
3 The fan is at the highest setting
2. Adjust angle direction
Switch off the fan. Slightly loosen the neck screw by turning it counter-
clockwise. Adjust the fan in the desired angular direction and tighten
the neck screw again by turning it clockwise.

CLEANING AND MAINTENANCE

• Switch off the fan and unplug it from the power supply before
assembling, disassembling or cleaning the fan.
Oscillation knob
Neck screw for adjusting wind
direction angle