mediPOOL PoolScan Bedienungsanleitung Seite 6

Operation
1. Switch the unit on using the ON/OFF key.
2. Swirl the instrument several times under the water
3. Close the lid tightly.
4. Press the ZERO/TEST key. "000" flashes for
5. Pelect the test required using the MODE key:
6. Open the lid and add the appropriate tablet straight
7. Crush the tablet using a clean stirring rod.
8. Close the lid and swirl the instrument gently for approx.
9. Afterwards keep the instrument steady and wait for
10. Press "Zero/Test". The "---" symbol flashes for approx.
6
Downloaded from www.Manualslib.com
(see pictures)
The display shows: "0". Make one Zero for all the
methods:
surface allowing the sample chamber to completely fill.
Take the instrument out of the water.
approx. 8 seconds. The display shows "0.0.0".
Cl (free Chlorine/ total Chlorine) → pH → TA →
CyA → Cl ... (Scroll).
from the foil.
Method
ClF : Free chlorine (ClF) DPD No.1
ClT : Total chlorine (Clt) DPD No.1 + DPD No.3
pH : pH Value
CyA : Cyanuric acid
TA : Alkalinity-M
Stir until the tablet is dissolved.
15 seconds.
15 seconds when testing ClF/pH/CyA and 2 minutes
when testing ClT and TA.
6 seconds. The result appears in the display (mg/l). Or:
LOW Result below lowest limit of measuring range
HIGH Measuring range exceeded
Repeat Test Press the "Zero/Test"-key
Change Method Take new sample.
Press the "Mode"- key to scroll down. Perform test.
New zero (Option)
Press the "Zero/Test"-key for 2 sec
manuals search engine
appropriate tablet
PHENOL RED PHOTOMETER
CyA-Test
ALKA-M-PHOTOMETER
.
GB