Gigahertz Solutions FF10 Bedienungsanleitung Seite 10

Downloaded from www.Manualslib.com
How to Mount the Frequency Filter
The scope of supply includes two alternative solutions to mount
the filter directly on top of the meter, allowing a single-hand
measurement.
4.
For a convenient one-hand-use, place the filter onto the meter as
shown on the front page ( "On"-switch facing to the right).
Connect antenna and analyser. When using the
meter with holster, the filter can easily be stabi-
lized with two fingers on the antenna cable (see
picture).
If need be, the filter can additionally be stabi-
lized with the help of a permanently elastic syn-
thetic latex band attached to the SMA sockets
on the left and right sides of the filter and
passed through underneath the instrument:
Then please connect the antenna onto the left socket and the
meter onto the right socket of the filter. Carefully bend the an-
tenna cable into the needed position, but take care not to kink it.
5.
Clear the adhesive surface from grease to ensure optimal ad-
hesion (e.g. with spirit or alcohol).
8
manuals search engine
Mounting with an elastic band
Mounting with a Velcro strap
Remove the bottom protective
foil from the Velcro block, and
adhere Velcro block onto the
top surface of the analyser be-
tween the meter name and the
VBW switch. Press tightly.
Remove the top protective foil
of the Velcro block, and place
the filter centrally onto it. Again
press tightly. Attach antenna
cable to the left SMA socket,
and the meter to the right SMA
socket of the filter.
© Gigahertz Solutions GmbH
FF10