Instruction Manual Cable Cutter - Weidmuller KT-F 36 Bedienungsanleitung

Instruction manual cable cutter

Mortal danger!
Do not live working!
Switch off current!
Risk of injury!
No extremities near the blades!
For flexibel copper and aluminium
cables or fine stranded up to Ø 36
mm.
Not suitable for cutting steel-ar-
moured cables, aluminium alloys
and hard drawn copper conduc-
tors!
The tool must only be used by inst-
ructed professionals.
General safety instructions
– Please read the instruction manual before
using the tool and use the tool only for the
specified application.
– Please observe the instructions during the
use and keep the safety instructions next to
the tool.
– Weidmüller assumes no liability for damages
or injuries caused by unsafe use of the tool,
defective maintenance or faulty application.
– The tool must only be repaired from the
manufacturer. If not, claims of the warranty
declaration expires.
4
Use
► Insert the cable and turn the blade (1) until
the edge of the blade rests on the cable.
► Do not cut angularly!
► Squeeze the handles (2) to manually operate
the blade (1) during the cutting process.
Risk of injury!
Danger of crushing during opening
cutting mechanism.
► Releasing the blade (1) is possible during
cutting proceeding as follows:
Squeeze handles (2) (both halves) together
until the retaining pawl (3) can easily be
disengaged. Keeping the retaining pawl (3)
down, release handle (2) and blade (1) turns
back into first position.
Maintenance
► Oil movable parts.
► Brush ratchet teeth.
2669500000/00/03.2019