Package Contents - TaoTronics TT-BH042 Handbuch

CN
产品图示
1. Micro USB充电口
7. 控制面板
2. 音量- / 上一曲 （长按）
8. 头带
3. LED指示灯
9. 电池
4. 多功能键
10. 耳钩
5. 音量+ / 下一曲 （长按）
11. 降噪麦克风
6. 麦克风 （接打电话）
12. 耳塞
EN

Package Contents

· 1 x TaoTronics Wireless ANC Earphones
· 1 x USB Charging Cable
· 6 x Ear Buds (two are already installed)
· 6 x Ear Hooks (two are already installed)
· 1 x User Guide
How to Use
1. Charging
1) Connect the charging port with any USB charging adapter or active computer
USB port.
2) Charging will start automatically with the LED indicator turning red.
3) The earphones are fully charged when the LED indicator turns blue.
Note:
· The LED indicator will flash red when the battery is low.
· Make sure the battery is fully charged before putting the earphones away for
storage.
· Charge the earphones at least once every 3 months when not using for a long
time.
2. Pairing
1) Make sure the earphones and your Bluetooth® device are next to each other
(within 3 feet / 1 meter).
2) Press and hold the Multifunction Button to bring the earphones into pairing
mode until you see the LED indicator flashing blue and red.
3) Activate Bluetooth® on your phone and search for nearby Bluetooth®
connections.
4) Find "TaoTronics TT-BH042" in the search results. Tap on the name to connect.
Once connected, the LED indicator will flash blue.
Note:
· The Bluetooth earphones can remember previously paired devices.
· If the earphones cannot pair with your Bluetooth® device, clear the pairing
history by pressing and holding the Volume + and Volume - buttons for 5
seconds until the LED Indicator turns purple with 2 beep sounds when the
earphones are on.
Control Functions
Function Operation
Press and hold the Multifunction Button until the
Power on / off
LED indicator flashes / turns off.
Play / Pause / Answer /Hang
Press the Multifunction Button once.
up phone calls
Press and hold the Multifunction Button for 2
Reject phone calls
seconds.
Press the Volume + / - Button.
Volume + / -
Press and hold the Volume - / + Button.
Previous / Next Track
ANC is turned on by default when the earphones
are powered on.
ANC on / off
Press the Multifunction Button twice to disable /
enable ANC.
01/02