Using The Dc Kit - Dometic GROUP WAECO DC-Kit4 Montage- Und Bedienungsanleitung

DC-Kit4
8

Using the DC Kit

The DC-Kit4 consists of several components, each with its own installation
and operating manual. Use the installation and operating manuals for the
components and make sure you are familiar with the individual devices.
This chapter contains information on operating the overall system. This oper-
ating manual does not replace any information contained in the installation
and operating instructions for the components.
A
NOTICE!
B3200, FJ1100, FJ1700, FJ2200, FJ2600, FJ3200: The
inverter may be damaged.
Ensure that these models are not used in the air conditioning or
heating modes for driving. The inverter is not designed for gener-
ating this amount of power.
A
NOTICE!
B3200, FJ1100, FJ1700, FJ2200, FJ2600, FJ3200: The
inverter may be damaged.
If you are operating the system on the 230 V mains and the auto-
matic air conditioner or the heating is on, make sure that the
inverter is switched off and stays switched off.
The inverter is not designed for the amount of power an
activeheating system requires. If the 230 V mains power fails, the
inverter would then take over supplying the power.
8.1 Switching on the system
Observe the following instructions before you switch on the system:
 Air the vehicle.
 Make sure that the ventilation slots on the air nozzles and the fan of the
components are not covered up.
 Make sure that all the housings and cables are not damaged and that all
the insulation is intact.
 Compare the existing supply voltage with the technical data.
 Do not insert any fingers or objects into component openings.
EN
Using the DC Kit
29