Suaoki U18 Benutzerhandbuch Seite 5

Note:
1.Do not charge the product immediately right after you use it to jump start your
car.
2.Make sure that the battery clamps are not connected to the product when you
are about to charge it.
3.It is advised not to charge the product continuously for more than 10 hours.
How to read the power indicator lights?
Click on the power button and the battery indicator light would be on.
Power Indicator Light
Power Level
1.When the jump starter is being charged, the power indicator light would blink to
indicate that it is not fully charged. When the product is fully charged, the 4
power indicator lights would stay on.
2.When you are using the USB ports or flashlight, the power indicator lights would
display the remaining battery level. When only one power indicator light blinks,
the product has a low battery level and needs to be charged immediately. If all
power indicator lights go off when you are using the product, the protection
mechanism is triggered due to low battery level.
How to jump start a 12V car?
Note: Check to make sure the power level is above 50% before you use the jump
start function.
DO NOT use the jump starter to start the car in high frequency. The time interval
between two starting attempts must be longer than 30s.
1.Insert the EC5 plug of the battery clamp to the jumping port of the product.
If the built-in battery of the jump starter works normally, the red and green
indicator lights would flash alternately. If the battery is not working normally, the
red indicator light would be on and the buzzer would beep.
2.Connect the red battery clamp to the positive terminal of the battery (+).
Connect the black clamp to the negative terminal of the battery (-). If the red
and black clamps are connected correctly, the green indicator light would stay
on. This means that you can start your car.
If things goes wrong...
• If the red and black clamps are connected in reverse, the alarm would go off.
1 light 2 lights
<25% <50%
EN-3
3 lights 4 lights
<75% <100%