Installation - Intelligent Facility Solutions GFM201 Montage- Und Benutzerhandbuch

INTRODUCTION
'Machflow' range hand dryers offer the following technical features:

Automatic operation. Hand detection is based on IR-type movement sensors.

They are class I devices, with earthing.

They provide a potent beam of air, intense and even.

The distance for detecting hands is adjustable.

The speed of the air generated by the hand dryer can also be adjusted, to achieve an
optimum balance between the drying power and noise level.

The hand dryers include an intelligent detection system which eliminates static 'targets'
(marble, shelves or similar). After detecting a static target, the dryer will disconnect a
few seconds later.

It includes a vandal-proof system with an automatic stop. Maximum continuous
functioning time is 60 seconds.

It includes a universal high speed motor that is activated gradually to control the inertia
of its ignition torque and thus ensure a longer useful life of the hand dryer.
ONLY A QUALIFIED TECHNICIAN CAN INSTALL, ADJUST AND MAINTAIN THIS HAND
DRYER, IN ORDER TO ACCOMPLISH THE LEGAL REQUIREMENTS.

INSTALLATION

Removal of the casing.

The hand dryer is supplied with the casing fitted to the base without tightening (Figure
1).

Carefully remove the casing since it is connected to the base by a tab that joins the two
pieces (casing and base) at the rear (Figure 2).

Remove the casing keeping it at an angle at all times (Figure 3) until the upper tab is
completely withdrawn, taking care to:
 not damage the internal components, in particular the electronic circuit,
 not scratch or damage the LED sensor screen,

ATTENTION: WHEN THE CASING IS DISMANTLED ACTIVE PARTS OF THE DEVICE
Figure 1.
not damage the surface of the casing.
BECOME ACCESSIBLE.
Figure 2.
11
Figure 3.