Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.1. SETTING UP THE STAND
• Determine a suitable location and position the stand.
• Release the tommy screw
retighten the tommy screw
The legs must always be extended completely. Operation with incompletely extended legs is prohibited.
• Verify that the stand is positioned vertically and correct if necessary. To do this, when screw
leg can be lengthened in order to position the stand vertically. Verify the vertical orientation of the stand using a
spirit level.
• Unfold the crank
• Now the load can be fastened. This can done using one of the three different mounts in the head of the stand (
and
9
10
• Once the tommy screws
height. When extending the stand, make certain that the safety catch
• Once the desired height is reached, retighten both tommy screws
Operation without the tommy screws
screws. Alternatively, the optionally available step (Product Number SWU375FR) can mounted and used to reach
the tommy screws.
• When used outdoors, the stand must be additionally stabilized with suitable guy lines. At the stand end, these
are fastened to anchor point
steel cables must be staked out at an angle of 120° relative to one another and at an angle of 30° relative to the
stand.
If the crank turns only with difficult, check the following points:
• Have the tommy screws
• Is the load too heavy (max. 30 kg)?
• Does the stand show signs of obvious damage?
3.2. TAKING DOWN THE STAND
• Release the tommy screws
• Move the safety catch
crank
.
4
CAUTION: When releasing the safety catch
avoid unintended lowering of the load!
• Use the crank
• Remove the load.
• Retighten the tommy screws
• Fold up the crank by releasing the knurled nut; afterwards, retighten the knurled nut.
• Release the tommy screw
this, the adjustable-length leg must be pushed in all the way. Afterwards, retighten the tommy screw
When transporting the stand, make certain that tommy screws
in, and the safety catch
Note: During transport, the stand must not be carried by the folded in crank
become damaged.
Downloaded from
www.Manualslib.com
and extend the legs completely by pushing down on the leg struts
1
.
1
after releasing the knurled nut
4
). The load must be mounted with the stand fully retracted.
have been released, the crank can be used to extended the stand to the desired
6
6
using a screw gate. The ropes must be attached to the ground with stakes. The
8
been loosened sufficiently?
6
.
6
to Position 2. In order to do this, it may be necessary to lift the load slightly using the
7
to slowly lower the load completely.
4
and return the safety catch
6
and fold in the legs completely by pushing up on the leg struts
1
is in Position 1.
7
manuals search engine
. Afterwards, retighten the knurled nut.
5
6
tightened is prohibited. If necessary, use a ladder to tighten the tommy
, always hold the crank
7
4
to Position 1.
7
,
and
1
3
2
is released, one
3
(Fig. 3) is in Position 1.
7
.
in position with the other hand in order to
. In order to do
2
are tightened, the crank
6
, as this could cause the crank to
4
. Afterwards,
.
1
is folded
4
9
Werbung
Inhaltsverzeichnis
