Adam Hall S10B Bedienungsanleitung

S10B
Tripod Microphone Stand with Boom Arm and Locking Leg
SAFTY INFORMATION
1. Please read these instructions carefully before you start installation and assembly.
2. Keep all information and instructions in a safe place.
3. Follow the instructions.
4. Observe all safety warnings. Never remove safety warnings or other information from the equipment.
5. Be attentive when setting up the product and protect yourself from injury.
6. A level surface is required, otherwise there is a high risk that it could fall over.
7. This product is intended for indoor use only. Using it outdoors could lead to product failure and personal injury.
8. Do not modify this equipment.
9. Comply with all applicable disposal laws in your country. During disposal of packaging, please separate
plastic and paper/cardboard.
10. Plastic bags must be kept out of reach of children.
11. If you have any questions refering to this instruction or any warnings, please contact your local distributor.
MANUFACTURER'S WARRANTY & LIMITATION OF LIABILITY
You can find our current warranty conditions and limitation of liability at: http://www.adamhall.com/media/shop/
downloads/documents/manufacturersdeclarations.pdf
To request warranty service for a product, please contact Adam Hall GmbH, Daimler Straße 9, 61267 Neu Ans-
pach / Email Info@adamhall.com / 49 (0) 6081 / 9419-0
PROPER DISPOSAL OF THIS PRODUCT
(WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT)
(Valid in the European Union and other European countries with waste separation)
This symbol on the product, or the documents accompanying the product, indicates that this appliance may not
be treated as household waste. This is to avoid environmental damage or personal injury due to uncontrolled
waste disposal. Please dispose of this product separately from other waste and have it recycled to promote
sustainable economic activity.
INTRODUCTION
This microphone boom stand is made of hardwearing steel tubing with black powder coating finish. It features
a diecast tripod base with locking leg that eliminates the need for a set screw. Folding the locking leg halfway
allows you to slide the leg collar up and down the shaft, folding it to the upper or lower stop locks the collar in
place for quick setup or compact transport.
FEATURES
Mic stand with boom arm
Steel with diecast leg collar
Collar locking leg
Black powder coating finish
SPECIFICATIONS
Adam Hall GmbH · Daimlerstr. 9 · 61267 Neu-Anspach · Germany
Tel.: (+49) 60 81 / 94 19 0 · Fax: (+49) 60 81 / 94 19 1000 · eMail: mail@adamhall.com
Model number:
Product type:
Type:
Tubing material:
Tubing colour:
Tubing surface:
Min. height:
Max. height:
Base material:
Boom:
Weight:
Additional information:
S10B
Stands and Tripods
Microphone Stands
steel
Black
powder coated
1000 mm
1600 mm
Cast
yes
1.8 kg
with One-Foot-Adjustment, with extendable boom