Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting; General Information; Warranty - TaoTronics TT-SL209 Handbuch

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 8
to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

GENERAL INFORMATION

This laser product complies with a CLASS 3A laser product to the requirements of the
US Federal Laser Product Performance Standard (FLPPS) contained in the regulations
in 21 CFR Sub-chapter J. CLASS 3A laser products can be hazardous when directly viewed.
Avoid direct viewing of a CLASS 3A laser energy. For reference the FLPPS requirements
for demonstration laser products like laser pointers are limited to CLASS 3A levels of
laser energy, this product uses diffractive optics to scatter the beam energy, this
scattering effect causes the energy concentration to drop below the exposure limits
for momentary or accidental viewing at relatively short distance from the laser
aperture. As similar with all bright light sources, when you operate this device in
unsupervised general public areas, it is recommended that up close access to the
laser lights be restricted or prevented.
This laser display device incorporates a CLASS 3A laser system which, by itself, may be
hazardous. However, this laser display device incorporates a protective housing and
diffractive holographic optics in the machine design such that there is no exposure or
human access to laser radiation during operation or maintenance above the CLASS
3A limits. Each individual laser beam power is under 5mW which is less than a
standard laser pointer.
SAVE THESE INSTRUCTIONS
Downloaded from
www.Manualslib.com
manuals search engine

Troubleshooting

Problems
Solutions
Check and make sure the product is plugged in
an active power source and switched on.
Light does not come on
Check if the socket works with an alternative
electrical product.
Switch the light off immediately and disconnect
Laser light is making unusual
from power. Please contact the TaoTronics
noises or smells.
Support Team.

Warranty

This product is covered by the TaoTronics Product and Labor Warranty for 12 months
from the date of its original purchase. If manufacturing defects occur, please contact
TaoTronics support (support@taotronics.com) immediately to launch a warranty claim.
We will instruct you on how to return the defective unit back to us for repair or
replacement. No return will be accepted without seller authorization.
09/10

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis