Daikin FWTSK Installations- Und Bedienungsanleitung Seite 5

FWTSK
F
UNCTIONS
The temperature sensor is used to:
■
Fan control (figure 1: A=Cooling, B=Heating, C=Water
temperature)
■
Heating Element (if it is present as heating support) (figure 2:
A=Heating, B=Water temperature)
■
Cooling/Heating switching depending on water temperature
(figure 3: A=Summer, B=Winter, C=Water temperature)
P
ROBE CONNECTION ON CONTROLLER
■
remote control using the supplied cable as accessory
■
■
■
■
the circuit board as indicated in the diagram (figure 5)
■
T
EMPERATURE SENSOR INSTALLATION
FWL-M-V I
Use the special copper holder for the temperature sensor and position
it as described below, depending on the type of installation.
W
ARNING
Fan coil units for:
■
■ 4 PIPE SYSTEMS - W/O VALVES: the temperature
■ 2 PIPE SYSTEMS - WITH VALVE: the temperature
■ 4 PIPE SYSTEMS - WITH VALVES: the temperature
FWD - I
NSTRUCTIONS FOR INSTALLATION
Ex: Valves mounted on left side: (figure 10: A=Temperature sensor for
4 pipe system, B=Temperature sensor for 2 pipe system, C=Air)
FWTSK
Temperature sensor
FC66002767
Downloaded from www.Manualslib.com
Connect the temperature FWTSK sensor to the
and, in case of prolongations, a shielded cable
only.
The shielding should be connected to the ground on
the fan coil side only.
The sensor cable (1.5 m) can be cut to measure
if necessary. Never place it near power supply
cables.
Open the controller after removing the screw of the
cover (figure 4)
Connect the probe to the connector and install it on
Close the controller
NSTRUCTIONS FOR INSTALLATION
:
2 PIPE SYSTEMS - W/O VALVE: the sensor must be
positioned on the heat exchanger (figure 6).
sensor must be positioned on the exchanger of the
heating circuit (figure 7).
sensor must be positioned at the valve inlet, on the
branch coming from the system (figure 8).
sensor must be positioned at the heating valve inlet,
on the branch coming from the circuit (figure 9).
manuals search engine
Temperature sensor
W
■ In the case of valveless FWD units for two-pipe sy-
■ In the case of valveless FWD units for four-pipe sy-
FWB - I
NSTRUCTIONS FOR INSTALLATION
Ex: Valves mounted on left side: (figure 11: A=System pipe to be
provided by the user)
W
■ In the case of valveless FWB units for two-pipe sy-
■ In the case of valveless FWB units for four-pipe sy-
NOTES
:
:
Installation and
operation manual
:
ARNING
stems, the temperature sensor must be positioned
on the pipe at the exchanger inlet.
stems, the temperature sensor must be positioned
on the pipe at the heating circuit exchanger inlet.
:
ARNING
stems, the temperature sensor must be positioned
on the pipe at the exchanger inlet.
stems, the temperature sensor must be positioned
on the pipe at the heating circuit exchanger inlet.
Installation and operation manual
:
1