ALPS Lite Benutzerhandbuch Seite 13

Night mode: touch button to activate and deactivate night
mode. The purifier then goes into slow speed and the lighting of
the controls is reduced.
Parental lock: Press the 3 seconds light to activate or
deactivate the parental lock. When the parental lock is
activated, the indicator light is green.
Filter change indicator: when the purifier has worked sufficiently
and the filter is saturated, the indicator light comes on. Press 3
seconds after changing the filter to reset the counter.
Replace the composite filter
1. Turn off the ALPS Lite purifier and then unplug it.
2. Remove the cover on the bottom of the purifier by turning it in the direction
shown (anti-clockwise).
3. Remove the filter located inside, which is then saturated.
4. Install a new filter in the location.
5. Attention, the filter has a meaning: the tab must remain on the bottom of the
purifier, and the foam surface must be inside.
6. Close and lock the cover by turning it in the direction indicated (clockwise).
7. Reconnect the ALPS Lite purifier, then turn it on.
8. Press the "filter change" indicator for 3 seconds to reset the counter.
Tips for proper use
● Continue to ventilate the room, 1 to 2 times a day. The air purifier does not
replace aeration or ventilation.
● After ventilating the room, turn on the air purifier at high speed (2 or 3) for 15
to 30 minutes depending on the size of the room.
● Then leave the purifier on at low speed (1) the rest of the time.
● When leaving the room or the accommodation, the purifier can be left on at
low speed (1). However, we recommend turning it off, and starting a fast
speed cycle, then a slow speed cycle, when returning to the room.
● Use one purifier per room, of suitable size. An open door between 2 rooms,
or a space requirement in a room, reduces its ability to fetch all the pollution.
13 | P a g e