Installation; Qg-1: Preparation; Qg-2: Label Check And Torso Structures Selection; Qg-3: Attach The Leg Pads To The Smart Joints - Laevo V2.57 Bedienungsanleitung

5

Installation

2
TIP
Read these steps while using the figures from the Quick-Guide. Figure numbers are indicated as
f
QG-1, QG-2, QG-3, etc.
Assembling the Laevo does not require any tools, except for the supplied M6 Allen wrench.
f

QG-1: Preparation

5.1
Check if the delivery is complete. See list of parts in QG-1.
f

QG-2: Label check and torso structures selection

5.2
In case of made-to-measure Laevo:
1. Check the label to verify the Laevo is for you.
2.
Do not wear a custom Laevo that is not for you.
3.
Do not use custom torso structures that are not for you.
In case of standard sizes:
Select the torso structure or Laevo size for first fitting from the table 'Body length to structure
f
indication' in 'Specifications' at the end of this manual.
2
TIP: Custom torso structures and Laevos are available for users that do not fit a standard
size.
2
TIP: Quick-Guide step 15 and 16 explain how and when to switch to a larger or smaller size.
5.3

QG-3: Attach the leg pads to the smart joints

1. Remove all packaging and tape from the leg pads.
2. Slide the left leg pad into the left smart joint.
3. Put the two screws in the two holes.
4. Tighten with the supplied key, until the screw heads hit the housing.
5.
Repeat for the right leg pad.

QG-4: Attach the suspenders to the chest pad and hip belt

5.4
Check if the suspenders are already fixed. If not:
f
1. Attach the suspenders to the hip belt.
2.
Make sure the Laevo logo faces outward and the buckles are below the crossing.
3.
Make sure the suspenders do not twist.
4. Attach the suspenders to the chest pad.
Wearable back support for repetitive bending and bended posture
EN
11